The is a versatile and efficient standalone access control unit designed to secure entry points for businesses, residential buildings, and other facilities. This comprehensive guide provides detailed instructions on everything from installation and wiring to advanced programming and user management.
The relay (PUSH1 and COM terminals) can be set to two different modes depending on the jumper configuration.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. V2000-c Rfid Access Control User Manual
This section details the programming menu for the V2000-C. The following sections summarise the primary programming commands based on the device keypad.
NC (Normally Closed – for Fail-Safe/Magnetic locks) Grey: BELL (Doorbell connection) 3. Programming Guide The is a versatile and efficient standalone access
: Keypad lockout triggered by too many invalid entry attempts.
The system will revert to factory defaults, and the Master Code will reset to its default sequence. Note: Saved user cards and PINs are typically retained during this specific hardware reset. Troubleshooting Guide Issue 1: Keypad keeps beeping and flashing red This public link is valid for 7 days
| Key | Function | Programming Steps | | :--- | :--- | :--- | | | Change System Password | Press 1 → Enter 5-digit new password (e.g., 88888) → Device beeps to confirm | | 2 | Add User (Card OR PIN) | Press 2 → Enter 4-digit User ID → Present Card OR enter 6-digit PIN → Device beeps | | 0 | Add User (Card AND PIN) | Press 0 → Enter 4-digit User ID → Present Card → Enter 6-digit PIN → Device beeps | | 3 | Delete User | Present Card OR enter 4-digit User ID of target user → Device confirms deletion | | # | Exit Programming Mode | Press # to return to normal standby state after finishing settings |