: 4-port Fast Ethernet or Gigabit Ethernet switch (model dependent).
Do you require the specific commands to configure or DHCP server pools?
: Connect the uplink cable (Fiber/Copper) to the designated WAN port for internet access. oneaccess one100 installation manual oneaccess top
VDSL2/ADSL2+, G.SHDSL, or Fast/Gigabit Ethernet interfaces (depending on your specific ONE100 sub-model).
According to the installation guide, the workflow is as follows: : 4-port Fast Ethernet or Gigabit Ethernet switch
OneOS(config)# interface vlan 1 OneOS(config-intf)# ip nat inside OneOS(config-intf)# exit OneOS(config)# interface fastethernet 0 OneOS(config-intf)# ip nat outside OneOS(config-intf)# exit OneOS(config)# access-list 1 permit 192.168.1.0 0.0.0.255 OneOS(config)# ip nat inside source list 1 interface fastethernet 0 overload Use code with caution. 6. System Security and Configuration Management
: Confirms line protocols, connection availability, and assigned IP addresses for all physical and virtual interfaces. VDSL2/ADSL2+, G
Connect the power adapter to the router's DC input jack, then plug the power cord into an AC outlet. Toggle the power switch to the ON position. 4. Establishing a Console Session
Ensure adequate ventilation space around the side cooling vents. Powering On the Device
Connect an Ethernet cable from one of the local LAN switch ports (1-4) to your local PC or corporate network switch.
Connect your local network switch or primary server to the available ports. Step 4: Connecting the Console Cable