Galaxy Aqua Premier Installation Manual Better !link!

Is this a or a replacement for an old unit?

Crucial Step. Before connecting the pipe to the shower, flush the pipework to remove debris. Debris is the #1 cause of solenoid valve failure.

This guide is a synthesis of general best practices and manufacturer information for Galaxy Aqua products and similar electric water heaters. Electrical and plumbing work can be dangerous if done incorrectly. Always consult your product's specific official manual and consider hiring a licensed professional for installation to ensure safety and compliance. galaxy aqua premier installation manual better

: It must be fitted permanently to fixed electrical wiring and in a location subject to freezing or inside a steam room. The Shower Doctor The "Hidden" Maintenance Realities

: Cold mains water only; do not connect to a gravity-fed tank supply. : Minimum running pressure of 1.0 bar (15 psi) at a flow rate of 9 litres/minute for the 9.5kW model. Electrical Is this a or a replacement for an old unit

Thread the adapter onto the cold water shut-off valve and tighten it firmly with a wrench.

Attach the drain saddle valve around your sink's drain pipe (above the P-trap). Drill a 1/4-inch hole into the pipe through the saddle, secure the saddle bolts, and run the reject-water tube from the "DRAIN" port of the machine into this saddle. Debris is the #1 cause of solenoid valve failure

Before picking up any tools, thorough preparation is the most critical step for a successful installation. Start by assembling all the necessary components, which are typically included in your purchase package.

Allow the internal storage tank to fill completely (this usually takes 45 to 60 minutes).

Never install the unit in areas subject to frost (like outdoors), as frost damage is not covered by the manufacturer's guarantee.

Avoid placing the unit directly under a leak-prone joint. 3. Plumbing Connection Flush the pipework to remove debris before connecting. Connect the 15mm cold water supply to the inlet manifold. Use the provided compression fitting; do not over-tighten.