The BY02VBPS features an automatic thread tension setting, which is suitable for most sewing projects. However, you can manually adjust the tension dial if necessary (e.g., when working with very thick or very thin fabrics). 4. Maintenance and Troubleshooting
Adjust the nozzle to the low-pressure setting to activate the siphon (check specific nozzle, usually a soap nozzle or soap tip). Apply the soap to the surface. 4. Maintenance and Cleaning by02vbps manual
: When using the built-in detergent bottle, ensure you use only approved pressure-washer-safe soaps. After use, flush the system with clean water to prevent soap buildup in the nozzle. The BY02VBPS features an automatic thread tension setting,
: Plug the unit into a dedicated, grounded 120V outlet. Never bypass or alter the Ground Fault Circuit Interrupter (GFCI) built into the power cord. Do not use extension cords. Maintenance and Troubleshooting Adjust the nozzle to the
Drain all water from the hose, gun, and pump before storing in freezing conditions.
If your pressure washer is not working correctly, refer to the table below: Potential Cause No power/not plugged in Check outlet and connection Thermal sensor activated Allow motor to cool for 10-15 mins No pressure/low pressure Clogged nozzle Clean the nozzle with tool Water supply too low Ensure water source is fully open Air in the system Purge air by running trigger w/o power Motor stops suddenly Overheating Turn off, allow to cool, restart No detergent flow Bottle empty/clogged Refill or clean detergent intake 6. End of Operation Instructions When you have finished your cleaning project: Turn the switch to the "OFF" position. Turn off the water supply.