Avery Berkel L126 | Calibration

: Locate a small screwdriver or a pen to access the internal hardware calibration switch (SW1). Step-by-Step Avery Berkel L126 Calibration Process

| Scale Capacity | Recommended Test Weight(s) | |------------------------|------------------------------------------------------------------| | Up to 30 kg | 10 kg, 20 kg, and 30 kg (or a single 30 kg weight) | | 30 kg – 300 kg | 50 kg, 100 kg, and 200 kg (multi‑point calibration preferred) | | 300 kg – 1500 kg | 500 kg, 1000 kg, and 1500 kg (use certified truck or pallet weights) |

Before entering the internal diagnostic software, prepare the testing environment. Eliminating external variables ensures that your load cells record exact linear spans.

The display will flash or show dashes while the internal processor records the dead-load voltage from the load cell. 3. Span Calibration (Span Weight) avery berkel l126 calibration

For more specific configurations or if the "DIAG" menu does not appear, you can consult the official documentation on the Avery Berkel Support Page.

Gently place your certified calibration weights onto the exact center of the scale platform. Press the blue button.

Follow these precise sequential steps to program your indicator: Step 1: Access the Diagnostic Menu : Locate a small screwdriver or a pen

Because the exact key sequence can vary, the following approach combines general Avery Berkel practices with specific L126 capabilities to guide you through the most common calibration process.

The screen will prompt you for the target calibration mass (e.g., displaying 15.000 for a 15kg capacity scale).

Ensure the scale platform is entirely clear of all objects, hooks, or debris. The digital screen will display . The display will flash or show dashes while

: The scale must be on a level, vibration-free surface. Even minor air currents can affect high-precision industrial indicators. Warm-up Time

Turn the scale off, wait 5 seconds, and turn it back on normally. Post-Calibration Testing

: Ensure the scale is empty and on a flat surface. When the screen says "Load Zero" , press the Test button . The scale will register the empty weight.

If this value does not match your physical calibration weight, press the red button to modify the target number.